data_collection_node_hardware
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
data_collection_node_hardware [2022/11/11 01:46] – [Sensors] glen | data_collection_node_hardware [2022/11/18 22:04] (current) – [Controller Hardware Evaluation] added rp2040 glen | ||
---|---|---|---|
Line 17: | Line 17: | ||
The following boards are candidates for data collection node hardware: | The following boards are candidates for data collection node hardware: | ||
- | ^ Board ^ Cost ^ RAM ^ Flash ^ Net ^ IO ^ Dev Tools ^ | + | ^ Board ^ Cost ^ RAM ^ Flash ^ Net ^ IO ^ Notes ^ |
- | | [[https:// | + | | [[https:// |
+ | | [[https:// | ||
| [[https:// | | [[https:// | ||
| [[https:// | | [[https:// | ||
Line 42: | Line 43: | ||
* Non-intrusive | * Non-intrusive | ||
* 120v, 240v | * 120v, 240v | ||
+ | |||
+ | ^ Device ^ Cost ^ Max Current ^ Notes ^ | ||
+ | | [[https:// | ||
+ | | [[https:// | ||
==== Water Temperature Sensor ==== | ==== Water Temperature Sensor ==== | ||
Line 50: | Line 55: | ||
* Submersible | * Submersible | ||
* I2C | * I2C | ||
- | ==== Ambient Temperature Sensor ==== | ||
- | Requirements: | + | [[https:// |
- | * Measure ambient temperature remote from board (insert into duct work for example) | + | |
- | * I2C | + | |
- | This may be as simple as something like a TO-92 based package wired to the board. | + | $10.95 |
+ | 1-wire interface | ||
+ | ==== Ambient Temperature/ | ||
+ | |||
+ | Used to monitor ambient temperature and humidity, especially in HVAC vents to help monitor HVAC health. | ||
+ | |||
+ | Component: [[https:// | ||
+ | * $19.95 | ||
+ | * QUICC | ||
+ | * Arduino library | ||
+ | * +/- 1degC | ||
+ | * Pressure, temperature, | ||
data_collection_node_hardware.1668131180.txt.gz · Last modified: 2022/11/11 01:46 by glen