data_collection_node_hardware
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
data_collection_node_hardware [2022/11/09 19:29] – glen | data_collection_node_hardware [2022/11/18 22:04] (current) – [Controller Hardware Evaluation] added rp2040 glen | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Data Collection Node Hardware ====== | ====== Data Collection Node Hardware ====== | ||
+ | |||
+ | Monitoring of power outages will require battery backed power. | ||
===== Requirements ===== | ===== Requirements ===== | ||
Line 11: | Line 13: | ||
* No OS to manage | * No OS to manage | ||
- | ===== Hardware Evaluation ===== | + | ===== Controller |
The following boards are candidates for data collection node hardware: | The following boards are candidates for data collection node hardware: | ||
- | ^ Board ^ Cost ^ RAM ^ Flash/SRAM ^ Net ^ IO ^ Dev Tools ^ | + | ^ Board ^ Cost ^ RAM ^ Flash ^ Net ^ IO ^ Notes ^ |
- | | [[https:// | + | | [[https:// |
+ | | [[https:// | ||
+ | | [[https:// | ||
| [[https:// | | [[https:// | ||
+ | | [[https:// | ||
+ | | [[https:// | ||
+ | |||
+ | ===== Sensors ===== | ||
+ | |||
+ | ==== Air Flow Sensor ==== | ||
+ | |||
+ | This sensor is used to monitor air flow in HVAC ducts. | ||
+ | |||
+ | Part: [[https:// | ||
+ | * $59.95 | ||
+ | * QUICC | ||
+ | * Arduino library | ||
+ | * 0-16mph, 12-bit resolution | ||
+ | ==== Current Measurement ==== | ||
+ | |||
+ | This sensor is used to measure device usage (like an EV charger) and also to detect when a device is running (HVAC unit). | ||
+ | |||
+ | Requirements | ||
+ | * Non-intrusive | ||
+ | * 120v, 240v | ||
+ | |||
+ | ^ Device ^ Cost ^ Max Current ^ Notes ^ | ||
+ | | [[https:// | ||
+ | | [[https:// | ||
+ | |||
+ | ==== Water Temperature Sensor ==== | ||
+ | |||
+ | This sensor is intended to measure temperate of a pool. | ||
+ | |||
+ | Requirements | ||
+ | * Submersible | ||
+ | * I2C | ||
+ | |||
+ | [[https:// | ||
+ | |||
+ | $10.95 | ||
+ | |||
+ | 1-wire interface | ||
+ | |||
+ | ==== Ambient Temperature/ | ||
+ | |||
+ | Used to monitor ambient temperature and humidity, especially in HVAC vents to help monitor HVAC health. | ||
+ | |||
+ | Component: [[https:// | ||
+ | * $19.95 | ||
+ | * QUICC | ||
+ | * Arduino library | ||
+ | * +/- 1degC | ||
+ | * Pressure, temperature, | ||
+ |
data_collection_node_hardware.1668022169.txt.gz · Last modified: 2022/11/09 19:29 by glen